Licensed plumbers, same-day installs, and hot water back on today

Water Heater Installation Decatur GA Done Right the First Time

When your water heater quits, you need water heater installation Decatur GA homeowners can count on. We install gas and electric tanks, tankless systems, and 50-gallon units across DeKalb County. Our licensed plumbers pull the permit, haul off the old tank, and test every connection before we leave. Call now and get hot water back the same day.

↗
Fast online booking

Request service today

Tell us what is happening. Our local team will confirm your visit shortly.

No spam. No obligation. Just practical help.
Thanks — we'll call shortly to confirm your visit.
Water Heater Installation in Decatur, Georgia
Careful work. Honest options.
About this service

Water Heater Installation Decatur GA: What the Job Actually Involves

Water heater installation Decatur GA is the licensed removal of your old tank or tankless unit and the code-compliant installation of a new one, including the supply lines, gas or electrical connections, venting, drain pan, and expansion tank. We start by shutting off the water and gas or power, draining the old tank, and checking the shut-off valve, pipe fittings, and venting for corrosion. Then we set the new unit, connect it with copper pipe or PEX tubing, and pressure-test every joint before we turn the water back on.

Most Decatur homes we see are running 10- to 15-year-old tanks that are one cold morning away from a puddle in the garage. If you are searching for water heater installation near me Decatur GA because your tank is leaking, popping, or running out of hot water halfway through a shower, we can usually get a new unit in the same day. We stock Rheem, Bradford White, and A.O. Smith tanks on the truck, so you are not waiting on a warehouse order.

  • ✓ Lower Monthly Gas Bills
  • ✓ Hot Water That Lasts
  • ✓ Code-Correct From Day One
  • ✓ No More Emergency Calls
What's included

What Our Water Heater Installation Includes

Every install includes the parts and labor that matter for a code-compliant job. We do not nickel-and-dime you on the basics. Here is what comes standard, and what we quote separately if your setup needs it.

✓

New Water Heater Unit

We supply Rheem, Bradford White, or A.O. Smith tanks in 40, 50, or 75 gallons, or a Navien tankless unit sized to your home. You pick the brand and efficiency level. We do not install customer-supplied units because we cannot warranty the parts.

✓

Permit and Inspection

We pull the Decatur plumbing permit and meet the DeKalb County inspector on site. That covers the venting, T&P relief valve, expansion tank, and electrical or gas connections. You get the signed inspection card for your records.

✓

Expansion Tank and Drain Pan

Georgia code requires an expansion tank on closed systems and a drain pan under any tank in a finished space. We install both as standard. The pan gets piped to a drain or the exterior so a future leak does not flood your floor.

✓

New Supply Lines and Fittings

We replace the flexible supply lines, install new copper pipe or PEX tubing, and swap out any corroded pipe fittings. Teflon tape and pipe dope go on every threaded connection. We pressure-test before we call it done.

✓

Old Unit Haul-Off

We drain the old tank, disconnect it, and carry it out. It goes on our truck and gets recycled. You do not have to schedule a separate pickup or pay a disposal fee.

✓

Walkthrough and Warranty

Before we leave, we show you the shut-off valve, the temperature setting, and the anode rod location. You get the manufacturer warranty paperwork and our labor warranty in writing. If something is not right, you call us, not a call center.

How it works

Our Water Heater Installation Process

01

Phone Assessment

We ask about your current unit, fuel type, family size, and whether you want tank or tankless. You get a ballpark range on the call and a firm price before we start work. No surprises, no upsells.

02

Permit and Prep

We pull the Decatur permit and confirm the inspection window. On install day, we lay drop cloths, shut off the water and gas or power, and drain the old tank into a hose run to your driveway or utility sink.

03

Removal and Haul-Off

We disconnect the old unit, cut out corroded pipe fittings, and haul the tank away. If your shut-off valve is seized or your venting is out of code, we fix it now rather than leave a problem behind the new unit.

04

New Unit Install

We set the new tank or tankless unit, connect gas or electrical, solder or crimp the supply lines, install the expansion tank and drain pan, and pressure-test every joint. Tankless venting gets run in PVC, CPVC, or stainless per the manufacturer.

05

Test and Walkthrough

We fill the tank, bleed the lines, light the pilot or power up the element, and run hot water at every fixture. You get a walkthrough of the shut-off, the temperature setting, and the warranty paperwork before we leave.

Tools & methods

Tools and Methods We Use on Every Install

Purpose-built equipment, used by trained technicians — so the job is done accurately the first time.

Pipe Wrench and Pipe Cutter

Used to break loose old galvanized or copper connections and cut pipe to length. A clean cut means a clean solder joint or PEX crimp, which means no drips behind the wall.

Soldering Torch and PEX Crimping Tool

We solder copper pipe for gas and hot water lines and use the PEX crimping tool for flexible supply runs. Both methods meet Georgia code and hold up to Decatur's water chemistry.

Water Heater Element Wrench

Used on electric units to remove and replace heating elements and to check anode rods. A worn element is the most common reason an electric tank stops making hot water.

Leak Detection Equipment

We use it to check for slab leaks, supply line drips, and T&P valve failures before and after an install. It catches problems that a visual inspection would miss.

Sewer Camera

Not every install is just an install. If we see signs of root intrusion or sewer line backup while we are on site, we camera the line and show you what we find.

Real results

Before and after.

Leaking 40-Gallon Tank in Oakhurst

Before

A 14-year-old tank was leaking from the bottom seam onto a finished basement floor. The homeowner had towels down and a bucket catching drips. The shut-off valve was seized and the venting was undersized.

After

We installed a new 50-gallon Bradford White tank, replaced the shut-off valve, corrected the venting to IPC spec, and added an expansion tank and drain pan. The floor dried out with no damage. Job took four hours.

Tankless Upgrade in Winnona Park

Before

A family of five was running out of hot water with a 40-gallon electric tank. The panel could not support a larger electric unit, and the gas line to the house was 1/2-inch, undersized for tankless.

After

We ran a new 3/4-inch gas line, installed a Navien tankless unit with stainless venting, and removed the old tank. Their gas bill dropped $22 the first month and they have not run out of hot water since.

Pre-Sale Inspection Fix in Downtown Decatur

Before

A home inspector flagged the water heater for missing expansion tank, improper venting, and no drain pan. The seller needed it corrected before closing in two weeks.

After

We pulled the permit, installed a new 50-gallon Rheem tank with expansion tank and drain pan, corrected the venting, and passed inspection in one visit. The sale closed on schedule with no repair credit.

Problems we solve

Problems We Solve With Water Heater Installation in Decatur

Most water heater calls start with one of these four problems. If any of them sound familiar, you are probably closer to a replacement than a repair. Here is what we do about each one.

Ask a pro →
01

Tank is leaking from the bottom

We shut off the water, drain the tank, and install a new unit the same day. We check the drain pan and floor for water damage and confirm the new tank is properly seated and vented.

↗
02

Running out of hot water too fast

We measure your first-hour rating and recommend the right size tank or a tankless unit. A 50-gallon tank or a properly sized Navien unit fixes the problem without oversizing your gas line.

↗
03

Rusty or metallic-smelling hot water

We replace the tank and flush your lines to clear the rust. If the issue is a failing anode rod, we check that too. A new unit with a fresh anode rod gives you clean hot water again.

↗
04

Popping or rumbling sounds from the tank

If the tank is under 10 years old, we can flush it and replace the heating element or burner. If it is older, we quote a new install. Either way, we show you what we find before we recommend anything.

↗
Transparent pricing

Water Heater Installation Cost in Decatur GA

$850 - $4,500 depending on unit type, size, and site conditions

Typical 2026 pricing for water heater installation in Decatur runs $850 to $1,800 for a standard tank swap and $2,200 to $4,500 for a tankless conversion. That range includes the unit, permit, haul-off, expansion tank, drain pan, and labor. What moves you up or down the range is fuel type, tank size, venting condition, and whether your gas line needs an upgrade. We give you a firm price before we start, so you are not guessing.

A new water heater lasts 10 to 15 years and uses 10 to 20 percent less gas than a failing unit. Spread over its life, that is a few dollars a month for reliable hot water and no emergency calls. We quote firm pricing upfront so you can plan.

01Tank vs. Tankless

A standard tank install is the lower-cost option. Tankless units cost more upfront because they need a larger gas line, stainless or PVC venting, and sometimes an electrical upgrade. The trade-off is lower gas bills and endless hot water.

03Fuel Type

Gas and electric installs are priced differently. Gas units need venting and a gas connection. Electric units need a dedicated circuit and a properly sized breaker. Both are straightforward, but the parts and labor differ.

04Venting and Code Upgrades

If your existing venting is undersized or your shut-off valve is seized, we fix it during the install. That adds $150 to $400 depending on what we find. We show you the problem and quote it before we do the work.

Proof you can check

Licensed, Insured, and Reviewed

✓
Georgia Master Plumber LicenseGeorgia State Plumbing Board License
✓
Journeyman Plumber LicenseGeorgia State Plumbing Board License
✓
Backflow Prevention CertificationGeorgia State Plumbing Board License
✓
OSHA Safety CertificationOccupational Safety and Health Administration
Customer reviews

What Decatur Homeowners Say

★★★★★
“Our 14-year-old tank started leaking on a Friday morning. I called at 9 a.m. and had a new 50-gallon Rheem installed by 2 p.m. the same day. They pulled the permit, hauled off the old unit, and even replaced a corroded shut-off valve they found. Floor was cleaner when they left than when they got there.”
MT

Marcus T.Homeowner, Oakhurst

✓ Verified
★★★★★
“I had three quotes for water heater replacement Decatur GA. These guys were the only ones who mentioned the expansion tank and the drain pan without me asking. Firm price, no surprises, passed inspection first try. I have already recommended them to two neighbors.”
PS

Priya S.Homeowner, Downtown Decatur

✓ Verified
Good questions

Frequently Asked Questions About Water Heater Installation

(831) 293-1204 →

Most standard tank installs in Decatur run $850 to $1,800 in 2026, including the unit, permit, haul-off, and parts. Tankless installs run $2,200 to $4,500 depending on gas line and venting work. Electric swaps are usually on the lower end. We give you a firm price before we start, so you are not guessing.

A standard tank swap takes two to four hours. Tankless conversions run four to eight hours because we often need to upsize the gas line and run new venting. If your shut-off valve is seized or your venting is out of code, add an hour. We schedule most installs the same day you call.

A one- to two-person home usually needs a 40-gallon tank. Three to four people need 50 gallons. Five or more, or a house with a soaking tub and two showers running at once, needs 75 gallons or a tankless unit sized to your flow rate. We calculate first-hour rating before we recommend anything.

Yes. Decatur and DeKalb County require a plumbing permit for water heater replacement, and the work has to pass inspection. We pull the permit for you and meet the inspector on site. Doing it without a permit can void your warranty and cause problems when you sell the house.

Ready when you are

Get Your Water Heater Installation Decatur GA Scheduled Today

Call now and we can often have a new tank installed the same day. Licensed plumbers, firm pricing, permit pulled, old unit hauled off. Hot water back on tonight.

Schedule Installation (831) 293-1204 →
Request an appointment

Contact Our Decatur Plumbing Team

Call us anytime, day or night. Our dispatch line is open 24/7 for emergencies, and our office is staffed Monday through Friday from 8 a.m. to 6 p.m. for scheduling and questions. We serve all of Decatur, Georgia and the surrounding DeKalb County area. If you have a leak, a clog, or no hot water, call now and we will get a plumber headed your way.

Request received — our team will be in touch shortly.
Tap to call(831) 293-1204